BRAKE PEDAL > REMOVAL |
| 1. REMOVE FRONT DOOR SCUFF PLATE LH |
| 2. REMOVE COWL SIDE TRIM BOARD LH |
| 3. REMOVE INSTRUMENT SIDE PANEL LH |
![]() |
Using a moulding remover, detach the 7 claws and remove the side panel.
| 4. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
![]() |
Detach the 3 claws.
Disconnect the hood lock control cable and remove the hood lock control lever sub-assembly.
| 5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
![]() |
Remove the 2 <A> bolts.
Detach the 9 clips and claw.
![]() |
Detach the 2 claws and remove the sensor.
Remove the finish panel and then disconnect the connectors.
| 6. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY |
![]() |
Remove the 4 bolts and remove the instrument panel airbag.
Detach the 2 claws and disconnect the DLC3.
Disconnect the connector.
| 7. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT |
![]() |
Remove the bolt and air duct.
| 8. REMOVE PUSH ROD PIN |
Remove the clip and push rod pin from the brake pedal lever.
| 9. REMOVE STOP LIGHT SWITCH ASSEMBLY |
Disconnect the connector.
![]() |
Turn the stop light switch counterclockwise and remove it.
| 10. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER |
Remove the stop light switch mounting adjuster.
| 11. REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY |
![]() |
Remove the brake pedal return spring.
Remove the bolt from the No. 3 brake pedal bracket.
![]() |
Remove the bolt, nut and No. 3 brake pedal bracket from the brake pedal support.
![]() |
Remove the 4 nuts and brake pedal support.
| 12. REMOVE BRAKE PEDAL PAD |
![]() |
Remove the brake pedal pad.