RELAY > ON-VEHICLE INSPECTION |
| 1. INSPECT HEADLIGHT CLEANER CONTROL RELAY |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 6 (PB)- 4 (E) | When battery voltage is not applied between terminals 3 (IG) and 2 (H) | 10 kΩ or higher |
| When battery voltage is applied between terminals 3 (IG) and 2 (H) | Below 1 Ω (0.8 to 0.9 seconds, then no continuity exists) |