Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM

DTC    B2780    Push Switch / Key Unlock Warning Switch Malfunction

for Preparation Click here


DESCRIPTION

This DTC will be output if the transponder key ECU does not detect that the unlock warning switch is on even when the ignition switch is ON. Under normal conditions, the unlock warning switch is on when the ignition switch is ON.

DTC Code
DTC Detection Condition
Trouble Area
B2780
Unlock warning switch ON is not detected when the ignition switch is ON.
  1. Transponder key ECU
  2. Unlock warning switch
  3. Harness or connector

WIRING DIAGRAM


B223951E01


INSPECTION PROCEDURE

HINT:
When the transponder key ECU is replaced, reregister the ECU - ECM communication ID.

1.READ VALUE USING INTELLIGENT TESTER (UNLOCK WARNING SWITCH)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Immobiliser / Data List.

  1. Use the Data List to check if the unlock warning switch is functioning properly.

    Immobiliser 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key SW
    Unlock warning switch signal / ON or OFF
    ON: Key is in ignition key cylinder
    OFF: No key is in ignition key cylinder
    -

    OK:
    ON (key is in ignition key cylinder) appears on the screen.



NG
Go to step 2
OK

REPLACE TRANSPONDER KEY ECU 

2.INSPECT UNLOCK WARNING SWITCH
B164411E14
  1. Remove the unlock warning switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Pushed
    Below 1 Ω
    Not pushed
    10 kΩ or higher



NG
REPLACE UNLOCK WARNING SWITCH (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - BODY GROUND)
B115727E08
  1. Disconnect the H21 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H21-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - TRANSPONDER KEY ECU)
B115728E09
  1. Disconnect the H21 switch connector.

  1. Disconnect the H32 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H32-3 (KSW) - H21-1
    Always
    Below 1 Ω
    H32-3 (KSW) or H21-1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU