DTC B2780 Push Switch / Key Unlock Warning Switch Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2780 | Unlock warning switch ON is not detected when the ignition switch is ON. |
|

| 1.READ VALUE USING INTELLIGENT TESTER (UNLOCK WARNING SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Immobiliser / Data List.
Use the Data List to check if the unlock warning switch is functioning properly.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Key SW | Unlock warning switch signal / ON or OFF | ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT UNLOCK WARNING SWITCH |
![]() |
Remove the unlock warning switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Pushed | Below 1 Ω |
| Not pushed | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - BODY GROUND) |
![]() |
Disconnect the H21 switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H21-2 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - TRANSPONDER KEY ECU) |
![]() |
Disconnect the H21 switch connector.
Disconnect the H32 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H32-3 (KSW) - H21-1 | Always | Below 1 Ω |
| H32-3 (KSW) or H21-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||