Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR CONTROL SWITCH (for Driver Side)

POWER BACK DOOR CONTROL SWITCH (for Driver Side) > INSPECTION

for Preparation Click here



1. INSPECT BACK DOOR CONTROL SWITCH


    B192521E02
  1. Inspect the resistance of the switch.

    Standard Resistance:
    Terminal No.
    Switch Condition
    Specified Condition
    3 (E) - 6 (CSW)
    Pushed
    Below 1 Ω
    3 (E) - 6 (CSW)
    Free
    10 kΩ or higher

    If the result is not as specified, replace the back door control switch.



    B194508E01
  1. Check the illumination operation.

    1. Connect the positive (+) battery lead to terminal 5 (ILL+) and the negative (-) battery lead to terminal 4 (ILL-), then check that the illumination illuminates.

      OK:
      Illumination illuminates.

      If the illumination does not illuminate, replace the back door control switch.