Home › Suspension › FRONT SUSPENSION › FRONT STABILIZER BAR

FRONT STABILIZER BAR > INSTALLATION

for Preparation Click here



1. INSTALL FRONT NO. 1 STABILIZER BAR BUSH


C155987E01
  1. Install the 2 bushes to the outer side of the bush stoppers on the front stabilizer bar as shown in the illustration.

    NOTICE:
    Be sure to install the front No. 1 stabilizer bar bushes so that the cut and bump of each bush faces the front of the vehicle.



2. TEMPORARILY INSTALL FRONT STABILIZER BAR
  1. Temporarily install the front stabilizer bar with the 4 bolts and the stabilizer bracket LH and RH.



3. TIGHTEN FRONT STABILIZER BRACKET


C155988
  1. Tighten the 4 bolts.

    Torque:
    69 N*m{ 704 kgf*cm , 51 ft.*lbf }



4. TEMPORARILY INSTALL FRONT STABILIZER LINK ASSEMBLY LH


C155989E01
  1. Temporarily install the stabilizer link with the nut and bolt.

  1. Tighten the nut.

    Torque:
    150 N*m{ 1530 kgf*cm , 111 ft.*lbf }



5. TEMPORARILY INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Use the same procedure for both sides.



6. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several times to stabilize the suspension.



7. TIGHTEN FRONT STABILIZER LINK ASSEMBLY LH


C162429E01
  1. Tighten the bolt.

    Torque:
    120 N*m{ 1224 kgf*cm , 89 ft.*lbf }



8. TIGHTEN FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Use the same procedure for both sides.



9. INSTALL FRONT WHEEL

Torque:
131 N*m{ 1336 kgf*cm , 97 ft.*lbf }