Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM

ENGINE IMMOBILISER SYSTEM > ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to operate the transponder key ECU.

WIRING DIAGRAM


E146075E06


INSPECTION PROCEDURE

1.INSPECT FUSES (IMB, IGN)
  1. Remove the IMB and IGN fuses from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    IMB fuse
    Always
    Below 1 Ω
    IGN fuse



NG
CHECK FOR SHORTS IN ALL HARNESSES AND CONNECTORS CONNECTED TO FUSE AND REPLACE FUSES
OK


2.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BATTERY AND BODY GROUND)


    B110782E28
  1. Disconnect the H32 ECU connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H32-16 (GND) - Body ground
    Always
    Below 1 Ω
    Standard Voltage 
    Tester Connection
    Switch Condition
    Specified Condition
    H32-1 (+B) - Body ground
    Always
    11 to 14 V
    H32-2 (IG) - Body ground
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)