Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › SKID CONTROL BUZZER

SKID CONTROL BUZZER > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



2. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



3. REMOVE INSTRUMENT SIDE PANEL LH


    B226739
  1. Using a moulding remover, detach the 7 claws and remove the side panel.



4. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B192511
  1. Detach the 3 claws.

  1. Disconnect the hood lock control cable and remove the hood lock control lever sub-assembly.



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


B229064
  1. Remove the 2 <A> bolts.

  1. Detach the 9 clips and claw.



    B163883
  1. Detach the 2 claws and remove the sensor.

  1. Remove the finish panel and then disconnect the connectors.



6. REMOVE SKID CONTROL BUZZER ASSEMBLY


    C154454
  1. Detach the clamp and remove the buzzer.

  1. Disconnect the buzzer connector.