CRUISE CONTROL SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Cruise Control / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| CCS Vehicle Spd | Vehicle speed / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph) | Actual vehicle speed | - |
| CCS Mem Vehicle Spd | Stored vehicle speed / min.: 0 km/h (0 mph), max.: 200 km/h (125 mph) | Actual stored vehicle speed | - |
| Throttle Opening Angle | Required throttle opening angle / min.: 0°, max.: 125° | Actual required throttle opening angle | - |
| Cruise Control | Cruise control system active condition / ON or OFF | ON: Cruise control activated OFF: Cruise control deactivated | - |
| CCS Main SW M-CPU | Main SW signal (Main CPU) / ON or OFF | ON: Main switch on OFF: Main switch off | "3" |
| CCS Ready M-CPU | Cruise control system standby condition (Main CPU) / ON or OFF | ON - OFF: Change ON/OFF each time main switch is pushed in. | "1" |
| CCS Indicator M-CPU | Cruise indicator signal (Main CPU) / ON or OFF | ON: "CRUISE" on OFF: "CRUISE" off | "2" |
| Cancel Switch | CANCEL SW signal / ON or OFF | ON: CANCEL Switch on OFF: CANCEL Switch off | - |
| SET/COAST Switch | -/SET SW signal / ON or OFF | ON: -/SET Switch on OFF: -/SET Switch off | - |
| RES/ACC Switch | +/RES SW signal / ON or OFF | ON: +/RES Switch on OFF: +/RES Switch off | - |
| Stop Light SW M-CPU | Stop light SW signal (Main CPU) / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released | - |
| Cruise Operation Status | Transmission range sensor signal / ON or OFF | ON: Shift lever in D or S4 range OFF: Shift lever not in D or S4 range | - |
| #Codes | Number of DTC recorded / 0 to 255 | Min.: 0 Max.: 255 | - |
| PERFORM ACTIVE TEST |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Active Test.
Perform "Active Test" according to the display on the intelligent tester.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Lamp Cruise | CRUISE main indicator light | Indicator light BLINK/OFF | - |