REAR POWER SEAT CONTROL SYSTEM > Power Source Circuit |

| 1.INSPECT FUSE |
![]() |
Remove the L1 RR2 SEAT, L2 RR2 SEAT, R1 RR2 SEAT and R2 RR2 SEAT fuses from the engine room relay block.
Remove the ECU-IG No. 2 fuse from the main body ECU.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ECU-IG No. 2 fuse | Always | Below 1 Ω |
| L1 RR2 SEAT fuse | Always | Below 1 Ω |
| L2 RR2 SEAT fuse | Always | Below 1 Ω |
| R1 RR2 SEAT fuse | Always | Below 1 Ω |
| R2 RR2 SEAT fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE) |
![]() |
Disconnect the O33 and O34 or P19 and P20 ECU connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| O33-4 (+B) - Body ground | Always | 11 to 14 V |
| O33-10 (+B2) - Body ground | Always | 11 to 14 V |
| O34-3 (IG) - Body ground | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
| Tester Connection | Switch Condition | Specified Condition |
| P19-4 (+B) - Body ground | Always | 11 to 14 V |
| P19-10 (+B2) - Body ground | Always | 11 to 14 V |
| P20-3 (IG) - Body ground | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (GROUND) |
![]() |
Disconnect the O33 or P19 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O33-8 (GND) - Body ground | Always | Below 1 Ω |
| O33-9 (GND2) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| P19-8 (GND) - Body ground | Always | Below 1 Ω |
| P19-9 (GND2) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||