REAR POWER SEAT CONTROL SYSTEM > INITIALIZATION |
| INITIALIZATION PROCEDURE |
Press the rear power seat switch in the forward position until the third-row seat is completely folded (stowed).
With the third-row seat in the completely folded position (stored), hold the rear power seat switch in the forward position for 1 more second.
The buzzer sounds twice when the initialization is complete.
| INITIALIZATION RELEASE PROCEDURE |
Press and hold the fold seat switch in the unfold direction (top of switch) until the seat is fully unfolded, and then release the switch.
Press and hold the rear power seat switch in the back direction (top of switch) until the seat is fully reclined, and then release the switch.
Press and hold down the fold seat switch in the unfold direction (top of switch), and without releasing the fold seat switch, press the rear power seat switch in the forward direction (bottom of switch) exactly 5 times within 10 seconds.
Continue to hold down the fold seat switch in the unfold direction (top of switch) until the buzzer sounds and the indicator light flashes 3 times (approximately 7 seconds). This indicates that the seat memory has been cleared and is ready to be initialized.