Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The stereo jack adapter assembly sends an external device sound signal to the radio receiver assembly through this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier assembly or radio receiver assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, radio receiver assembly, or speakers.

WIRING DIAGRAM


E146453E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - STEREO JACK ADAPTER ASSEMBLY)


    E145924E02
  1. Disconnect the I3 radio receiver assembly connector.

  1. Disconnect the H7 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I3-17 (ALI) - H7-1 (ALO)
    Always
    Below 1 Ω
    I3-15 (ARI) - H7-2 (ARO)
    I3-16 (ASGN) - H7-3 (ASGN)
    I3-18 (AUXG) - H7-5 (AUXG)
    I3-19 (AUXI) - H7-4 (AUXO)
    I3-17 (ALI) - Body ground
    Always
    10 kΩ or higher
    I3-15 (ARI) - Body ground
    I3-16 (ASGN) - Body ground
    I3-19 (AUXI) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)