AIR CONDITIONING PRESSURE SENSOR > ON-VEHICLE INSPECTION |
| 1. INSPECT AIR CONDITIONER PRESSURE SENSOR |
![]() |
Install the manifold gauge set.
Disconnect the connector from the air conditioner pressure sensor.
Connect the three 1.5 V dry cell batteries' positive (+) lead to terminal 3 and the negative (-) lead to terminal 1.
Connect the positive (+) lead of a DC 5 V power source to terminal 3 and the negative (-) lead to terminal 1.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Refrigerant pressure: 0.39 to 3.187 MPa (4 to 32.5 kgf/cm2, 57 to 463 psi) | 1.0 to 4.9 V |