Home › Vehicle Exterior › DOOR / HATCH › FUEL LID OPENER MOTOR ASSEMBLY

FUEL LID OPENER MOTOR ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FUEL LID WITH MOTOR LOCK ASSEMBLY


    B262233E01
  1. Apply battery voltage to the motor terminals and check that the motor operates and the shaft moves in the open direction.
    Text in Illustration 
    *a
    Component without harness connected
    (Fuel Lid with Motor Lock Assembly)
    *b
    Shaft Stroke
    V100135
    Open

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Motor operates and shaft moves in open direction

    If the result is not as specified, replace the fuel lid with motor lock assembly.

  1. Measure the shaft stroke.

    Standard:
    9 to 13 mm (0.354 to 0.511 in.)

    If the result is not as specified, replace the fuel lid with motor lock assembly.