Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Reverse Signal Circuit

for Preparation Click here


DESCRIPTION

The navigation receiver assembly receives a reverse signal from the park/neutral position switch assembly to use for adjusting the vehicle position on the navigation display.

WIRING DIAGRAM


E226161E27


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK PARK/NEUTRAL POSITION SWITCH ASSEMBLY (REVERSE SIGNAL)


    E221772E21
  1. Disconnect the navigation receiver assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I53-2 (REV) - Body ground
    Ignition switch ON
    Shift lever in R
    11 to 14 V
    I53-2 (REV) - Body ground
    Ignition switch ON
    Shift lever in any position other than R
    Below 1 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Navigation Receiver Assembly)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH ASSEMBLY)
  1. Disconnect the I53 navigation receiver assembly connector.

  1. Disconnect the D21 park/neutral position switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I53-2 (REV) - D21-1 (RL)
    Always
    Below 1 Ω
    I53-2 (REV) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    E179071E15
  1. Remove the park/neutral position switch assembly.

    1. for AB60E (Click here)
    2. for AB60F (Click here)

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (RL) - 2 (RB)
    Shift lever in R
    Below 1 Ω
    1 (RL) - 2 (RB)
    Shift lever in P
    10 kΩ or higher

    Result 
    Result
    Proceed to
    NG (for AB60E)
    A
    NG (for AB60F)
    B
    OK
    C



B
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)