NAVIGATION SYSTEM > Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the I50 navigation receiver assembly connector.
Disconnect the I51 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I50-2 - I51-2 | Always | Below 1 Ω |
| I50-3 - I51-3 | Always | Below 1 Ω |
| I50-2 - Body ground | Always | 10 kΩ or higher |
| I50-3 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||