AUDIO AND VISUAL SYSTEM > Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter |

| 1.CHECK OPERATION OF SPEEDOMETER |
Drive the vehicle and check if the function of the speedometer on the combination meter is normal.
|
| ||||
| OK | |
| 2.CHECK RADIO RECEIVER ASSEMBLY (SPEED SIGNAL) |
![]() |
Disconnect the I3 radio receiver assembly connector.
Jack up the drive wheels.
Move the shift lever to N.
Turn the ignition switch to ON.
Using an oscilloscope, check the signal waveform of the combination meter assembly.
| Item | Content |
| Tester Connection | I3-3 (SPD)*1 - Body ground |
| Tool Setting | 5 V/DIV., 20 msec./DIV |
| Condition | Drive vehicle at 20 km/h (12 mph) |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - RADIO RECEIVER ASSEMBLY) |
![]() |
Disconnect the I3 radio receiver assembly connector.
Disconnect the H37 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I3-3 (SPD) - H37-35 (+S) | Always | Below 1 Ω |
| I3-3 (SPD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||