Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter

for Preparation Click here


DESCRIPTION

This circuit is necessary for the ASL (Auto Sound Levelizer) built into the radio receiver.
Speed signals are received from the combination meter and used for the ASL.
The ASL function automatically adjusts the sound data in order to enable the driver to hear clear audio sound even when vehicle noise increases (as vehicle noise increases, the volume is turned up, etc.).

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter. The signal is changed to a pulse signal at the transistor in the combination meter. Each ECU controls the respective system based on the pulse signal.
  2. If a short occurs in an ECU, all systems in the diagram below will not operate normally.


WIRING DIAGRAM


E182362E01


INSPECTION PROCEDURE

1.CHECK OPERATION OF SPEEDOMETER
  1. Drive the vehicle and check if the function of the speedometer on the combination meter is normal.

    OK:
    Actual vehicle speed and the speed indicated on the speedometer are the same.

    HINT:
    1. The speed indicated on the speedometer has an allowable margin of error. This can be tested using a speedometer tester (calibrated chassis dynamometer). For details about testing and the margin of error, refer to "Operation Check" in the meter/gauge system (Click here).
    2. The vehicle speed sensor is functioning normally when the indication on the speedometer is normal.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2.CHECK RADIO RECEIVER ASSEMBLY (SPEED SIGNAL)


    E182363E01
  1. Disconnect the I3 radio receiver assembly connector.

  1. Jack up the drive wheels.

  1. Move the shift lever to N.

  1. Turn the ignition switch to ON.

  1. Using an oscilloscope, check the signal waveform of the combination meter assembly.
    Measurement Condition 
    Item
    Content
    Tester Connection
    I3-3 (SPD)*1 - Body ground
    Tool Setting
    5 V/DIV., 20 msec./DIV
    Condition
    Drive vehicle at 20 km/h (12 mph)

    OK:
    Voltage pulses as shown in the illustration.

    HINT:
    As the vehicle speed increases, the wavelength shortens.



NG
Go to step 3
OK

REPLACE RADIO RECEIVER ASSEMBLY (Click here)  

3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - RADIO RECEIVER ASSEMBLY)


    E182364E01
  1. Disconnect the I3 radio receiver assembly connector.

  1. Disconnect the H37 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I3-3 (SPD) - H37-35 (+S)
    Always
    Below 1 Ω
    I3-3 (SPD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)