BLACK OUT TAPE (for Front Door) > INSTALLATION |
| 1. INSTALL NO. 1 BLACK OUT TAPE |
Application precautions.
Application temperature.
Pre-application procedure.
Handling.
Application method (method of squeegee operation and application for general portions).

![]() |
Application method (method of squeegee operation).
Application method (method of squeegee operation and application method for corner sections).
Inspection.
Clean the attachment surface (using an infrared light).
Using an infrared light, heat any black out tape and adhesive remaining on the body.
Using a piece of cloth, rub the remaining black out tape and adhesive off the body.
Using a non-residue solvent, clean the attachment surface.
Clean the attachment surface (using a tape removal disc).
Set the 8 discs in the holder and insert the removal disc into an air drill or electric drill.
Using a tape removal disc, rub the remaining black out tape and adhesive off the body.
Using a non-residue solvent, clean the attachment surface.
Apply new No. 1 black out tape to the positions shown in the illustration.

| Item | Measurement |
| a | 2.0 mm (0.0787 in.) |
| b | 1.0 mm (0.0394 in.) or less |
| c | 3.0 mm (0.118 in.) |
| 2. INSTALL FRONT DOOR GLASS RUN |
| 3. INSTALL FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY |
![]() |
Attach the 5 claws and clip to install a new front door glass outer weatherstrip.
| 4. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY |
![]() |
Temporarily install the mirror by inserting the claw on the mirror into the holes on the vehicle.
Tighten the 3 nuts in the sequence shown in the illustration and install the mirror.
| 5. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
| 6. INSTALL FRONT ARMREST BASE UPPER PANEL |
| 7. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG |
| 8. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH |