Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BLACK OUT TAPE (for Front Door)

BLACK OUT TAPE (for Front Door) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure described below is for the LH side.



1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

HINT:
Use the same procedure as for the RH side .



2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

HINT:
Use the same procedure as for the RH side .



3. REMOVE FRONT ARMREST BASE UPPER PANEL

HINT:
Use the same procedure as for the RH side .



4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side .



5. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY


B190501
  1. Disconnect the connector.

  1. Remove the 3 nuts.

  1. Detach the claw and remove the outer rear view mirror assembly.



6. REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY


B191700E01
  1. Apply protective tape to the door panel in the area around the front door glass outer weatherstrip.



    B191701E01
  1. Using a moulding remover, detach the 5 claws and the clip, and remove the front door glass outer weatherstrip.



7. REMOVE FRONT DOOR GLASS RUN

HINT:
Use the same procedure as for the RH side .



8. REMOVE NO. 1 BLACK OUT TAPE


    B195426
  1. Using an infrared light, heat the No. 1 black out tape.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

    CAUTION:
    Do not burn yourself on the hot front door panel or with the infrared light.

  1. Lift the end portion with your nail and peel it parallel to the attachment surface.