BLACK OUT TAPE (for Rear Door) > REMOVAL |
| 1. REMOVE REAR DOOR WINDOW FRAME REAR MOULDING |
| Item | Temperature |
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Rear Door Window Frame Rear Moulding | 20 to 30°C (68 to 86°F) |
![]() |
Put protective tape around the rear door window frame rear moulding.
Using a moulding remover, detach the 2 clips and remove the double-sided tape to remove the rear door window frame rear moulding.
| 2. REMOVE REAR DOOR GLASS OUTER WEATHERSTRIP |
![]() |
Apply protective tape to the door panel in the area around the rear door glass outer weatherstrip.
![]() |
Using a moulding remover, detach the 5 claws and the clip, and remove the rear door glass outer weatherstrip.
| 3. REMOVE REAR DOOR FRAME GARNISH |
| 4. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG |
| 5. REMOVE REAR DOOR ARMREST BASE UPPER PANEL |
| 6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY |
| 7. REMOVE REAR DOOR GLASS RUN |
| 8. REMOVE NO. 2 BLACK OUT TAPE |
![]() |
Using an infrared light, heat the No. 2 black out tape.
Lift the end portion with your nail and peel it parallel to the attachment surface.