Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BLACK OUT TAPE (for Rear Door)

BLACK OUT TAPE (for Rear Door) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure described below is for the LH side.



1. REMOVE REAR DOOR WINDOW FRAME REAR MOULDING

HINT:
When removing the rear door window frame rear moulding, heat the vehicle body and rear door window frame rear moulding using a heat light.

Standard:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Rear Door Window Frame Rear Moulding
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body or rear door window frame rear moulding excessively.



    B256625E01
  1. Put protective tape around the rear door window frame rear moulding.

  1. Using a moulding remover, detach the 2 clips and remove the double-sided tape to remove the rear door window frame rear moulding.



2. REMOVE REAR DOOR GLASS OUTER WEATHERSTRIP


B191703E01
  1. Apply protective tape to the door panel in the area around the rear door glass outer weatherstrip.



    B191704E01
  1. Using a moulding remover, detach the 5 claws and the clip, and remove the rear door glass outer weatherstrip.



3. REMOVE REAR DOOR FRAME GARNISH

HINT:
Use the same procedure as for the RH side .



4. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

HINT:
Use the same procedure as for the RH side .



5. REMOVE REAR DOOR ARMREST BASE UPPER PANEL

HINT:
Use the same procedure as for the RH side .



6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side .



7. REMOVE REAR DOOR GLASS RUN

HINT:
Use the same procedure as for the RH side .



8. REMOVE NO. 2 BLACK OUT TAPE


    B195427
  1. Using an infrared light, heat the No. 2 black out tape.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

    CAUTION:
    Do not burn yourself on the hot rear door panel or with the infrared light.

  1. Lift the end portion with your nail and peel it parallel to the attachment surface.