Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

POWER STEERING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the power steering system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CUSTOMER PROBLEM ANALYSIS

      NEXT


      4.PROBLEM SYMPTOM CONFIRMATION

        NEXT


        5.CHECK CAN COMMUNICATION SYSTEM*
        1. Check for DTCs (Click here).
          Result 
          Result
          Proceed to
          CAN system DTC is not output
          A
          CAN system DTC is output
          B

          HINT:
          1. When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.
          2. When communication to the power steering ECU is not established through the intelligent tester, inspect terminals CANH and CANL of the DLC3 and the power steering ECU, and the IG circuit of the power steering ECU.



        B.
        PROCEED TO CAN COMMUNICATION SYSTEM
        A


        6.CHECK VEHICLE STABILITY CONTROL SYSTEM*
        1. Check for DTCs (Click here).
          Result 
          Result
          Proceed to
          DTC output
          A
          DTC not output
          B

          HINT:
          When any vehicle stability control system DTCs are output, perform troubleshooting on the vehicle stability control system first.



        A.
        PROCEED TO VEHICLE STABILITY CONTROL SYSTEM
        B


        7.CHECK SFI SYSTEM*
        1. Check for DTCs (Click here).
          Result 
          Result
          Proceed to
          DTC output
          A
          DTC not output
          B

          HINT:
          When any SFI system DTCs are output, perform troubleshooting on the SFI system first.



        A.
        PROCEED TO SFI SYSTEM
        B


        8.PROBLEM SYMPTOMS TABLE
          Result 
          Result
          Proceed to
          Fault is not listed in problem symptoms table
          A
          Fault is listed in problem symptoms table
          B


        B.
        Go to step 10
        A


        9.OVERALL ANALYSIS AND TROUBLESHOOTING
        1. Terminals of ECU (Click here).


        NEXT


        10.REPAIR OR REPLACE

          NEXT


          11.CONFIRMATION TEST*

            NEXT

            END