Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / (desired system) / Data List.

  5. According to the display on the intelligent tester, read the "Data List".

    Master Switch 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Door P/W Auto SW
    Driver side power window auto UP/DOWN switch signal / ON or OFF
    ON: Driver side power window auto UP/DOWN switch on power window regulator master switch operated
    OFF: Driver side power window switch on power window regulator master switch not operated
    -
    P Door P/W Auto SW
    Front passenger side power window remote auto UP/DOWN switch signal / ON or OFF
    ON: Front passenger side power window remote auto UP/DOWN switch on power window regulator master switch operated
    OFF: Front passenger side power window switch on power window regulator master switch not operated
    -
    P Door P/W Up SW
    Front passenger side power window remote manual UP switch signal / ON or OFF
    ON: Front passenger side power window remote manual UP switch on power window regulator master switch operated
    OFF: Front passenger side power window switch on power window regulator master switch not operated
    -
    P Door P/W Down SW
    Front passenger side power window remote manual DOWN switch signal / ON or OFF
    ON: Front passenger side power window remote manual DOWN switch on power window regulator master switch operated
    OFF: Front passenger side power window switch on power window regulator master switch not operated
    -
    Window Lock Switch Status
    Power window LOCK switch / ON or OFF
    ON: The Power window lock switch LOCK position
    OFF: The Power window lock switch UNLOCK position
    -
    Number of Trouble Codes
    Number of trouble codes / Min.: 0, Max.: 255
    Number of DTCs will be displayed
    -

    D-Door Motor 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Door P/W auto switch
    Driver side power window auto UP/DOWN switch signal / ON or OFF
    ON: Driver side power window auto UP/DOWN switch operated
    OFF: Driver side power window switch not operated
    -
    D Door P/W up switch
    Driver side power window MANUAL UP switch signal / ON or OFF
    ON: Driver side power window manual UP switch operated
    OFF: Driver side power window switch not operated
    -
    D Door P/W down switch
    Driver side power window MANUAL DOWN switch signal / ON or OFF
    ON: Driver side power window manual DOWN switch operated
    OFF: Driver side power window switch not operated
    -
    Number of Trouble Codes
    Number of trouble codes / Min.: 0, Max.: 255
    Number of DTCs will be displayed
    -

    P-Door Motor 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    P Door P/W auto switch
    Front passenger side power window auto UP/DOWN switch signal / ON or OFF
    ON: Front passenger side power window auto UP/DOWN switch operated
    OFF: Front passenger side power window regulator switch not operated
    -
    P Door P/W up switch
    Front passenger side power window manual UP switch signal / ON or OFF
    ON: Front passenger side power window manual UP switch operated
    OFF: Front passenger side power window regulator switch not operated
    -
    P Door P/W down switch
    Front passenger side power window manual DOWN switch signal / ON or OFF
    ON: Front passenger side power window manual DOWN switch operated
    OFF: Front passenger side power window regulator switch not operated
    -
    Number of Trouble Codes
    Number of trouble codes / Min.: 0, Max.: 255
    Number of DTCs will be displayed
    -

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Door Courtesy SW
    Driver side door courtesy switch signal / ON or OFF
    ON: Driver door open
    OFF: Driver door closed
    -
    P Door Courtesy SW
    Front passenger side door courtesy switch signal / ON or OFF
    ON: Front passenger door open
    OFF: Front passenger door closed
    -
    Door Lock SW-Lock
    Driver side door lock switch signal / ON or OFF
    ON: Driver side door lock switch is turned to lock
    OFF: Key is in Driver side door lock key cylinder (original position)
    -
    Door Lock SW-Unlock
    Driver side door unlock switch signal / ON or OFF
    ON: Driver side door lock switch is turned to unlock
    OFF: Key is in Driver side door lock key cylinder (original position)
    -
    Door Key P/W Up
    Function to roll the driver side door window down while holding the key to the unlock side more than about 0.7 second. / ON or OFF
    Customize setting displayed
    -
    Door Key P/W Down
    Function to roll the driver side door window up while holding the key to the lock side more than about 0.7 second. / NOT ON or OFF
    Customize setting displayed
    -
    Communication D-Door Motor
    Connection status between power window regulator motor (for driver side) and main body ECU/OK or Stop
    OK: Connection
    Stop: No connection
    -
    Communication P-Door Motor
    Connection status between power window regulator motor (for front passenger side) and main body ECU/OK or Stop
    OK: Connection
    Stop: No connection
    -
    Communication Master SW
    Connection status between master switch and main body ECU/OK or Stop
    OK: Connection
    Stop: No connection
    -
    Communication B-Dor P/W
    Connection status between back door ECU and main body ECU/OK or Stop
    OK: Connection
    Stop: No connection
    -

    Back Door P/W 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key Switch Operation Locked
    Tail gate control switch signal / ON or OFF
    ON: Tail gate control switch is turned to lock
    OFF: Key is in back door lock key cylinder (original position)
    -
    Key Switch Operation Unlocked
    Tail gate control switch signal / ON or OFF
    ON: Tail gate control switch is turned to unlock
    OFF: Key is in back door lock key cylinder (original position)
    -
    Wiper Reverse Position
    Rear wiper reverse position switch signal / ON or OFF
    ON: Rear wiper reverse position switch is in ON position
    OFF: Rear wiper reverse position switch is in OFF position
    -
    Wiper Retracted Position
    Rear wiper retract switch signal / ON or OFF
    ON: Rear wiper retract switch is in ON position
    OFF: Rear wiper retract switch is in OFF position
    -
    Door Key Linked Unlock SW
    Function to roll the back door window down while holding the key to the unlock side more than about 0.7 second. / NOT AVL or AVAIL
    Customize setting displayed
    -
    Door Key Linked Lock SW
    Function to roll the back door window up while holding the key to the lock side more than about 0.7 second. / NOT AVL or AVAIL
    Customize setting displayed
    -
    Back Door P/W Status
    Back door glass position signal / Close or Open
    Close: Back door glass is in Close position
    Open: Back door glass is in Open position
    -
    Back P/W Pos (Close-1/4 open)
    Door glass position (Fully closed - 1/ 4 open) signal / OK or Caution
    OK: Power window is going UP by manual operation
    Caution: Caution may be displayed when resistance is applied in each position. In this case, there must be a foreign object stuck in that position
    -
    Back P/W Pos (1/4-2/4 open)
    Door glass position (1/4 open - 2/4 open) signal / OK or Caution
    OK: Power window is going UP by manual operation
    Caution: Caution may be displayed when resistance is applied in each position. In this case, there must be a foreign object stuck in that position
    -
    Back P/W Pos (2/4-3/4 open)
    Door glass position (2/4 open - 3/4 open) signal / OK or Caution
    OK: Power window is going UP by manual operation
    Caution: Caution may be displayed when resistance is applied in each position. In this case, there must be a foreign object stuck in that position
    -
    Back P/W Pos (3/4-Full open)
    Door glass position (3/4 open - Fully open) signal / OK or Caution
    OK: Power window is going UP by manual operation
    Caution: Caution may be displayed when resistance is applied in each position. In this case, there must be a foreign object stuck in that position
    -


PERFORM ACTIVE TEST

HINT:
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / (desired system) / Active Test.

  5. According to the display on the intelligent tester, perform the "Active Test".

    HINT:
    Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function does not operate.


    D-Door Motor 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Power Window
    Driver side power window
    OFF/UP/DOWN
    -

    P-Door Motor 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Power Window
    Front passenger side power window
    OFF/UP/DOWN
    -

    Back Door P/W 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Back Door Power Window
    Back door power window
    OFF/UP/DOWN
    -

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    IG OFF P/W Control Permission Output
    Power window control permission output
    ON or OFF
    -