Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR CLOSER SYSTEM

BACK DOOR CLOSER SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. The back door closer system troubleshooting procedure is based on the premise that the power back door system is operating normally. Check the power back door system first before troubleshooting the back door closer system (Click here).
  2. Use the procedure to troubleshoot the back door closer system.
  3. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the intelligent tester to check if the CAN communication system is functioning normally.
      Result 
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    4.CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*
    1. Use the intelligent tester to check if the LIN communication system is functioning normally.
      Result 
      Result
      Proceed to
      LIN DTC is not output
      A
      LIN DTC is output
      B



    B.
    GO TO LIN COMMUNICATION SYSTEM (Click here)
    A


    5.CHECK FOR DTC*
    1. Check for DTCs (Click here).

    2. Clear the DTCs (Click here).

    3. Recheck for DTCs (Click here).
      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    GO TO DTC CHART (Click here).
    A


    6.PROBLEM SYMPTOMS TABLE
      Result 
      Result
      Proceed to
      Fault is not listed on Problem Symptoms Table
      A
      Fault is listed on Problem Symptoms Table
      B


    B.
    Go to step 8
    A


    7.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation Check (Click here)

    2. Terminals of ECU (Click here)

    3. Data List/Active Test (Click here)


    NEXT


    8.REPAIR OR REPLACE

      NEXT


      9.CONFIRMATION TEST

        NEXT

        END