BACK DOOR CLOSER SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
| |||||
| 3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN communication system is functioning normally.
| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output | B |
|
| ||||
| |||||
| 4.CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the LIN communication system is functioning normally.
| Result | Proceed to |
| LIN DTC is not output | A |
| LIN DTC is output | B |
|
| ||||
| |||||
| 5.CHECK FOR DTC* |
Check for DTCs (Click here).
Clear the DTCs (Click here).
Recheck for DTCs (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
| Result | Proceed to |
| Fault is not listed on Problem Symptoms Table | A |
| Fault is listed on Problem Symptoms Table | B |
|
| ||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Operation Check (Click here)
Terminals of ECU (Click here)
Data List/Active Test (Click here)
| |||||
| 8.REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|