Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > Slip Indicator Light Remains ON

for Preparation Click here


DESCRIPTION

The slip indicator light blinks during VSC and/or TRC operation.
When the system fails, the slip indicator light comes on to warn the driver (Click here).

WIRING DIAGRAM


C244860E05


INSPECTION PROCEDURE

NOTICE:
When replacing the VSC actuator assembly, perform zero point calibration (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SLIP INDICATOR LIGHT)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester ON.

  1. Select the Active Test mode and operate the slip indicator light using the intelligent tester.

    ABS/VSC/TRC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Slip Indicator Light
    Slip indicator light
    Indicator light ON/OFF
    Observe combination meter

  1. Check that the slip indicator light turns on and off in the combination meter when using the intelligent tester.

    OK:
    The slip indicator light turns ON and OFF in accordance with the intelligent tester operation.

    HINT:
    When the slip indicator light remains illuminated, there may be an open in the wire harness of the combination meter or abnormalities in the meter circuit.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK

REPLACE VSC ACTUATOR ASSEMBLY (Click here)