VEHICLE STABILITY CONTROL SYSTEM > VSC OFF Indicator Light does not Come ON |
| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK CONNECTOR CONNECTION CONDITION |
Check the skid control ECU connector connection condition.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the A19 ECU connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A19-8 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
| A19-16 (GND1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (VSC OFF INDICATOR LIGHT) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester ON.
Select the Active Test mode and operate the VSC OFF indicator light using the intelligent tester.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| VSC OFF Indicator Light | VSC OFF indicator light | Indicator light ON/OFF | Observe combination meter |
Check that the VSC OFF indicator light turns ON and OFF in the combination meter when using the intelligent tester.
|
| ||||
| OK | ||
| ||