DTC C0273/13 Open in ABS Motor Relay Circuit |
DTC C1251/51 Open in Pump Motor Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| C0273/13 | When one of following conditions is met:
|
|
| C1251/51 | When any of following conditions detected with normal battery voltage (10 V or higher):
|
|

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (MOTOR RELAY) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester ON.
Clear the DTC (Click here).
Select the Active Test mode on the intelligent tester.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Motor Relay | Motor relay | Relay ON/OFF | Operating sound of motor can be heard |
Check the operation sound of the motor when operating it with the intelligent tester.
|
| ||||
| OK | |
| 2.RECONFIRM DTC |
Clear the DTC (Click here).
Start the engine.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||
| 3.INSPECT FUSE (ABS1) |
![]() |
Remove the ABS1 H-fuse from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ABS1 H-fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the A19 ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A19-1 (+BM) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A19-16 (GND1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||