PROPELLER SHAFT ASSEMBLY (for 2WD) > DISASSEMBLY |
| 1. INSPECT PROPELLER SHAFT ASSEMBLY |
![]() |
Using a dial indicator, check the propeller shaft runout.
| 2. INSPECT UNIVERSAL JOINT SPIDER BEARING |
![]() |
Mount the propeller shaft in a vise.
Inspect the spider bearing for wear or damage.
Using a dial indicator, measure the spider bearing axial play by turning the yoke of the flange while holding the shaft tightly.
| 3. REMOVE REAR PROPELLER SHAFT UNIVERSAL J0INT SPIDER |
![]() |
Place matchmarks on the universal joint sleeve yoke and propeller shaft.
![]() |
Using needle-nose pliers, remove the 4 hole snap rings.
Fix the propeller shaft assembly in a vise between aluminum plates.
![]() |
Using a screwdriver, remove the 4 slingers of the spider bearing.
![]() |
Using SST, pull the universal joint spider bearing from the propeller shaft.
![]() |
Clamp the removed universal joint spider bearing in a vise.
Using a brass bar and hammer, tap the propeller shaft to remove the universal joint spider bearing.
Remove the universal joint sleeve yoke and universal joint spider from the propeller shaft.
![]() |
Using SST, pull out the universal joint spider bearing from the universal joint sleeve yoke.
![]() |
Clamp the removed universal joint spider bearing in a vise.
Using a brass bar and hammer, tap the universal joint sleeve yoke to remove the universal joint spider bearing.
Remove the universal joint spider from the universal joint sleeve yoke.