Home › Drivetrain ยท DRIVE SHAFT / PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY (for 4WD)

PROPELLER SHAFT ASSEMBLY (for 4WD) > DISASSEMBLY

for Preparation Click here



1. INSPECT PROPELLER SHAFT ASSEMBLY


    C160098
  1. Using a dial indicator, measure the propeller shaft runout.

    Maximum runout:
    1.02 mm (0.0402 in.)

    1. If the shaft runout is greater than the maximum, replace the propeller shaft.



2. INSPECT UNIVERSAL JOINT SPIDER BEARING


    C158513
  1. Inspect the spider bearing for wear or damage.

  1. Using a dial indicator, measure the spider bearing axial play by turning the yoke of the flange while holding the shaft tightly.

    Maximum runout:
    0.05 mm (0.00197 in.)

    1. If the spider bearing axial play exceeds the maximum, replace the spider bearing.



3. REMOVE REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER

HINT:
Use the same removal procedure for both the front and rear propeller shaft universal joint spiders.



    C179260E02
  1. Place matchmarks on the universal joint sleeve yoke and propeller shaft's universal joint flange yoke.



    C179262
  1. Remove the grease fitting from the spider bearing.



    C179263E01
  1. Using needle-nose pliers, remove the 4 hole snap rings.

  1. Fix the propeller shaft assembly in a vise between aluminum plates.



    C184732
  1. Using a screwdriver, remove the 4 slingers of the spider bearing.



    C184643E01
  1. Using SST, pull the universal joint spider bearing from the propeller shaft's universal joint flange yoke.

    SST
    09950-40011   (09951-04010, 09952-04010, 09953-04020, 09954-04010, 09957-04010, 09958-04011)
    09955-04100  
    09331-60010  

    NOTICE:
    Pull out the spider bearing until the SST claws contact the propeller shaft's universal joint flange yoke.



    C179267E01
  1. Clamp the removed universal joint spider bearing in a vise.

  1. Using a brass bar and hammer, tap the propeller shaft's universal joint flange yoke to remove the universal joint spider bearing.

    NOTICE:
    Do not tap the propeller shaft tube.

    HINT:
    Use the same removal procedure for the universal joint spider bearing on the opposite side.

  1. Remove the universal joint flange yoke and universal joint spider from the propeller shaft.



    C184645E01
  1. Using SST, pull out the universal joint spider bearing from the universal joint flange yoke.

    SST
    09950-40011   (09951-04010, 09952-04010, 09953-04020, 09954-04010, 09957-04010, 09958-04011)
    09955-04100  
    09331-60010  

    NOTICE:
    Pull out the spider bearing until the SST claws contact the universal joint sleeve yoke.



    C179271E01
  1. Clamp the removed universal joint spider bearing in a vise.

  1. Using a brass bar and hammer, tap the universal joint flange yoke to remove the universal joint spider bearing.

    HINT:
    Use the same removal procedure for the universal joint spider bearing on the opposite side.

  1. Remove the universal joint spider from the universal joint flange yoke.