DTC B2341 Sensor (Motor) Failure |
DTC B2344 Position Failure |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2341 | Sensor (Motor) Failure | Sliding roof drive gear (Sliding roof ECU) |
| B2344 | Position Failure | Sliding roof drive gear (Sliding roof ECU) |
| 1.CHECK DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
| Result | Proceed to |
| DTC B2341 or B2344 is output | A |
| DTC B2343 is output | B |
| No DTC is output | C |
|
| ||||
|
| ||||
| A | |
| 2.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Sliding Roof / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Hall IC1 Pulse | Sliding roof operation signal/LO or HI | LO: Sliding roof motor is not operating HI: Sliding roof motor is operating | - |
| Hall IC1 Status | Sliding roof operation signal/NORMAL or LOCK | NORMAL: Sliding roof motor is operating LOCK: Sliding roof motor is not operating | - |
| Hall IC2 Pulse | Sliding roof operation signal/LO or HI | LO: Sliding roof motor is not operating HI: Sliding roof motor is operating | - |
| Hall IC2 Status | Sliding roof operation signal/NORMAL or LOCK | NORMAL: Sliding roof motor is operating LOCK: Sliding roof motor is not operating | - |
|
| ||||
| OK | |
| 3.CHECK DTC |
Check for DTCs (Click here).
| Result | Proceed to |
| DTC B2341 or B2344 is output | A |
| No DTC is output | B |
|
| ||||
| A | ||
| ||