Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SYSTEM

DTC    B2341    Sensor (Motor) Failure

DTC    B2344    Position Failure

for Preparation Click here


DESCRIPTION

When the sliding roof drive gear (sliding roof ECU) detects malfunctions in the motor, and the sliding roof operation is stopped, DTC B2341 is stored.
When the sliding roof drive gear (sliding roof ECU) detects malfunctions in the gear, and the sliding roof operation is stopped, DTC B2344 is stored.

DTC Code
DTC Detection Condition
Trouble Area
B2341
Sensor (Motor) Failure
Sliding roof drive gear (Sliding roof ECU)
B2344
Position Failure
Sliding roof drive gear (Sliding roof ECU)

INSPECTION PROCEDURE

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B2341 or B2344 is output
    A
    DTC B2343 is output
    B
    No DTC is output
    C



B
GO TO B2343 (Click here)

C
USE SIMULATION METHOD TO CHECK (Click here)
A


2.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Sliding Roof / Data List.

  1. According to the display on the intelligent tester, read the Data List.

    Sliding Roof 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Hall IC1 Pulse
    Sliding roof operation signal/LO or HI
    LO: Sliding roof motor is not operating
    HI: Sliding roof motor is operating
    -
    Hall IC1 Status
    Sliding roof operation signal/NORMAL or LOCK
    NORMAL: Sliding roof motor is operating
    LOCK: Sliding roof motor is not operating
    -
    Hall IC2 Pulse
    Sliding roof operation signal/LO or HI
    LO: Sliding roof motor is not operating
    HI: Sliding roof motor is operating
    -
    Hall IC2 Status
    Sliding roof operation signal/NORMAL or LOCK
    NORMAL: Sliding roof motor is operating
    LOCK: Sliding roof motor is not operating
    -

    OK:
    The intelligent tester displays as shown in the table according to the sliding roof motor operation.



NG
REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU) (Click here)
OK


3.CHECK DTC
  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B2341 or B2344 is output
    A
    No DTC is output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU) (Click here)