EMISSION CONTROL SYSTEM (w/o Secondary Air Injection System) > ON-VEHICLE INSPECTION |
| 1. INSPECT FUEL CUT-OFF RPM |
Start and warm up the engine.
Open the throttle valve and keep the engine speed at 3000 rpm.
Use a sound scope to check for injector operating noise.
Check that when the accelerator pedal is released, injector operation noise stops momentarily and then resumes.
If the result is as not specified, check the injector, wiring and ECM.
| 2. VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS |
![]() |
Check that there are no cracks, leaks or damage.
| 3. INSPECT FUEL CUT-OFF VALVE AND FILL CHECK VALVE |
Disconnect the vent line hose from the fuel tank.

Connect the pressure gauge to the fuel tank.
Fill the fuel tank with fuel.
Apply pressure of 4 kPa (41 gf/cm2, 0.6 psi) to the vent port of the fuel tank.
Remove the fuel tank cap, and check that the pressure inside the tank drops.
If pressure does not drop, replace the fuel tank assembly.
Reconnect the vent line hose to the fuel tank.
| 4. CHECK AIR INLET LINE |
![]() |
Disconnect the air inlet line hose from the charcoal canister.
Check that there is ventilation in the air inlet line.
Reconnect the air inlet line hose to the charcoal canister.