Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM

DTC    B2221    Jam Protection Pulse Sensor Circuit on Back Door

for Preparation Click here


DESCRIPTION

The back door ECU monitors the condition of the power window motor and detects the position of the door glass by using pulse signals output from the 2 pulse sensors in the power window motor.

DTC Code
DTC Detection Condition
Suspected Part
B2221
  1. PLS1 pulse sensor circuit malfunction
  2. PLS2 pulse sensor circuit malfunction
  3. Pulse direction is opposite to motor rotating direction (Short circuit between PLS1 and PLS2)
  4. PLS1 and PLS2 pulse sensors circuit malfunction
  5. Fully closed position is misaligned
  1. Back door Power window regulator motor
  2. Back door ECU
  3. Harness or connector

FAIL-SAFE

If the pulse sensor in the back door power window regulator motor malfunctions (DTC B2221 is output), the power window functions will be restricted:
  1. The AUTO UP/ DOWN function is disabled.
  2. The MANUAL UP/DOWN function via the back door power window switch can be performed with the ignition switch ON.
  3. The MANUAL UP/DOWN function via the back door lock key cylinder can be performed with the ignition switch ON.

WIRING DIAGRAM


B178351E01


INSPECTION PROCEDURE

1.PERFORM INITIALIZATION (BACK DOOR POWER WINDOW REGULATOR MOTOR)
  1. Initialize the back door power window regulator motor (Click here).


NEXT


2.CHECK DTC
  1. Clear the DTC (Click here).

  1. Check for DTC (Click here).

    OK:
    DTC is not output.



NG
Go to step 3
OK

END 

3.CHECK HARNESS AND CONNECTOR (BACK DOOR ECU - BACK DOOR POWER WINDOW REGULATOR MOTOR)


    B178352E01
  1. Disconnect the V3 back door ECU connector.

  1. Disconnect the V4 back door power window regulator motor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    V3-12 (DSV) - V4-4 (SSRB)
    Always
    Below 1 Ω
    V3-13 (DS1) - V4-3 (PLS1)
    Always
    Below 1 Ω
    V3-14 (DS2) - V4-5 (PLS2)
    Always
    Below 1 Ω
    V3-23 (DSG) - V4-6 (LMTE)
    Always
    Below 1 Ω
    V3-12 (DSV) - Body ground
    Always
    10 kΩ or higher
    V3-13 (DS1) - Body ground
    Always
    10 kΩ or higher
    V3-14 (DS2) - Body ground
    Always
    10 kΩ or higher
    V3-23 (DSG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE BACK DOOR POWER WINDOW REGULATOR MOTOR
  1. Replace back door power window regulator motor .


NEXT


5.CHECK DTC
  1. Clear the DTC (Click here).

  1. Check for DTC (Click here).

    OK:
    DTC is not output.



NG
REPLACE BACK DOOR ECU
OK

END