THERMOSTAT > REMOVAL |
| 1. REMOVE V-BANK COVER SUB-ASSEMBLY |
![]() |
Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
| 2. REMOVE NO. 1 ENGINE UNDER COVER |
![]() |
Remove the 3 screws and 5 bolts.
Unhook the engine under cover from the vehicle body as shown in the illustration.
| 3. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Remove the radiator cap. Then drain the coolant from the radiator.
Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.
Tighten the 2 cylinder block drain cock plugs.
Tighten the radiator drain cock plug by hand.

| 4. DISCONNECT NO. 3 AIR INJECTION SYSTEM HOSE (w/ Secondary Air Injection System) |
![]() |
Disconnect the No. 3 air injection hose.
| 5. DISCONNECT NO. 2 AIR INJECTION SYSTEM HOSE (w/ Secondary Air Injection System) |
![]() |
Disconnect the connector and separate the wire harness clamp.
Disconnect the No. 2 air injection hose.
| 6. SEPARATE AIR PIPE SUB-ASSEMBLY (w/ Secondary Air Injection System) |
![]() |
Disconnect the connector and separate the 2 clamps and wire harness.
Remove bolt and separate the air pipe.
| 7. DISCONNECT OUTLET RADIATOR HOSE |
![]() |
Disconnect the outlet radiator hose from the water inlet housing.
| 8. DISCONNECT NO. 5 WATER BY-PASS HOSE |
![]() |
Disconnect the No. 5 water by-pass hose.
| 9. REMOVE INLET WATER SUB-ASSEMBLY WITH THERMOSTAT |
![]() |
Remove the 3 nuts, water inlet with thermostat and gasket.