Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > Park / Neutral Position Switch Circuit

for Preparation Click here


DESCRIPTION

This circuit sends the park/neutral position switch signals to the clearance warning ECU.

WIRING DIAGRAM


B144584E06


INSPECTION PROCEDURE

1.INSPECT PARK/NEUTRAL POSITION SWITCH


    E181648E01
  1. Disconnect the D21 park/neutral position switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Condition
    Condition
    Specified Condition
    6 (PL) - 2 (RB)
    Shift lever in P
    Below 1 Ω
    1 (RL) - 2 (RB)
    Shift lever in R
    Below 1 Ω
    6 (PL) - 2 (RB)
    Shift lever not in P
    10 kΩ or higher
    1 (RL) - 2 (RB)
    Shift lever not in R
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK
    A
    NG (for AB60E)
    B
    NG (for AB60F)
    C



B
REPLACE PARK/NEUTRAL POSITION SWITCH (Click here)

C
REPLACE PARK/NEUTRAL POSITION SWITCH (Click here)
A


2.CHECK HARNESS AND CONNECTOR (SWITCH - BATTERY)


    E181990E01
  1. Disconnect the D21 park/neutral position switch connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Condition
    Switch Condition
    Specified Condition
    D21-2 (RB) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (SWITCH - CLEARANCE WARNING ECU)


    B144078E04
  1. Disconnect the D21 park/neutral position switch connector.

  1. Disconnect the H43 clearance warning ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Condition
    Condition
    Specified Condition
    D21-6 (PL) - H43-1 (PL)
    Always
    Below 1 Ω
    D21-1 (RL) - H43-13 (RL)
    D21-6 (PL) - Body ground
    Always
    10 kΩ or higher
    D21-1 (RL) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)