Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > Front Clearance Sonar Sensor LH Circuit

for Preparation Click here


DESCRIPTION

The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance value between the vehicle and the obstacle, and sends the distance value as a signal to the clearance warning ECU.

WIRING DIAGRAM


E132021E16


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (FRONT CORNER SENSOR LH - FRONT CORNER SENSOR RH)


    B144572E26
  1. Disconnect the C1 and B1 front corner No. 1 ultrasonic sensor connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C1-1 (BI) - B1-2 (BO)
    Always
    Below 1 Ω
    C1-3 (SI) - B1-4 (SO)
    C1-5 (EI) - B1-6 (EO)
    C1-1 (BI) - Body ground
    Always
    10 kΩ or higher
    C1-3 (SI) - Body ground
    C1-5 (EI) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)