Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > Rear Clearance Sonar Sensor LH Circuit

for Preparation Click here


DESCRIPTION

The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance value between the vehicle and the obstacle, and sends the distance value as a signal to the clearance warning ECU.

WIRING DIAGRAM


E132021E20


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (REAR CORNER SENSOR LH - BACK SENSOR LH)


    B144572E27
  1. Disconnect the R1 rear corner No. 1 ultrasonic sensor connector.

  1. Disconnect the R4 back No. 2 ultrasonic sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R1-1 (BI) - R4-2 (BO)
    Always
    Below 1 Ω
    R1-3 (SI) - R4-4 (SO)
    R1-5 (EI) - R4-6 (EO)
    R1-1 (BI) - Body ground
    Always
    10 kΩ or higher
    R1-3 (SI) - Body ground
    R1-5 (EI) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)