TOYOTA PARKING ASSIST-SENSOR SYSTEM > Rear Clearance Sonar Sensor LH Circuit |

| 1.CHECK HARNESS AND CONNECTOR (REAR CORNER SENSOR LH - BACK SENSOR LH) |
![]() |
Disconnect the R1 rear corner No. 1 ultrasonic sensor connector.
Disconnect the R4 back No. 2 ultrasonic sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R1-1 (BI) - R4-2 (BO) | Always | Below 1 Ω |
| R1-3 (SI) - R4-4 (SO) | ||
| R1-5 (EI) - R4-6 (EO) | ||
| R1-1 (BI) - Body ground | Always | 10 kΩ or higher |
| R1-3 (SI) - Body ground | ||
| R1-5 (EI) - Body ground |
|
| ||||
| OK | ||
| ||