Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > Back Sonar Sensor RH Circuit

for Preparation Click here


DESCRIPTION

The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance value between the vehicle and the obstacle, and sends the distance value as a signal to the clearance warning ECU.

WIRING DIAGRAM


E132021E19


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (BACK SENSOR RH - REAR CORNER SENSOR RH)


    B144572E25
  1. Disconnect the R3 back No. 2 ultrasonic sensor connector.

  1. Disconnect the R2 rear corner No. 1 ultrasonic sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Condition
    Condition
    Specified Condition
    R3-1 (BI) - R2-2 (BO)
    Always
    Below 1 Ω
    R3-3 (SI) - R2-4 (SO)
    R3-5 (EI) - R2-6 (EO)
    R3-1 (BI) - Body ground
    Always
    10 kΩ or higher
    R3-3 (SI) - Body ground
    R3-5 (EI) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)