REAR CRANKSHAFT OIL SEAL > INSTALLATION |
| 1. INSTALL ENGINE REAR OIL SEAL |
Apply MP grease to the lip of a new oil seal.
![]() |
Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
| 2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
![]() |
Using SST, hold the crankshaft.
Install the crankshaft angle sensor plate, drive gear and rear drive plate spacer to the crankshaft.
![]() |
Install and uniformly tighten 10 new bolts in the sequence shown in the illustration.
![]() |
Mark the upside of each flywheel installation bolt with paint.
Tighten the flywheel installation bolts another 90° as shown.
Check that the painted marks are now at a 90° angle to the upside.
| 3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY |
for 4WD:
Install the automatic transmission assembly (Click here).
for 2WD:
Install the automatic transmission assembly (Click here).