Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > Back Door Glass goes Down During Auto Up Operation

for Preparation Click here


DESCRIPTION

If the door glass or the power window regulator does not smoothly operate, the jam protection function may operate abnormally, resulting in this symptom.

INSPECTION PROCEDURE

1.PERFORM INITIALIZATION
  1. Initialize the back door window regulator motor (Click here).

  1. Check that the AUTO UP/DOWN function operates normally.

    OK:
    Back door power window AUTO UP/DOWN operates normally.



NG
Go to step 2
OK

END 

2.CHECK BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY
  1. Remove the back door glass.

  1. Operate the power window regulator via the back door power window switch while the back door glass is not installed.

  1. Check that the power window regulator operates smoothly.

    OK:
    Power window moves smoothly.



NG
REPLACE BACK DOOR POWER WINDOW REGULATOR MOTOR
OK

REPLACE BACK DOOR GLASS RUN