TOYOTA PARKING ASSIST-SENSOR SYSTEM > Vehicle Speed Signal Circuit |

| 1.CHECK OPERATION OF SPEEDOMETER |
Drive the vehicle and check if the function of the speedometer on the combination meter is normal.
|
| ||||
| OK | |
| 2.CHECK COMBINATION METER ASSEMBLY (SPEED SIGNAL) |
![]() |
Disconnect the H43 clearance warning ECU connector.
Jack up the drive wheels.
Move the shift lever to N.
Turn the ignition switch to ON.
Using an oscilloscope, check the signal waveform of the meter.
| Item | Content |
| Tester Connection | H43-3 (SPD) - Body ground |
| Tool Setting | 5 V/DIV., 20 msec./DIV. |
| Condition | Drive vehicle at 20 km/h (12 mph) |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - COMBINATION METER ASSEMBLY) |
![]() |
Disconnect the H43 clearance warning ECU connector.
Disconnect the H37 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H43-3 (SPD) - H37-35 (+S) | Always | Below 1 Ω |
| H43-3 (SPD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||