Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > Vehicle Speed Signal Circuit

for Preparation Click here


WIRING DIAGRAM


E280653E04


INSPECTION PROCEDURE

1.CHECK COMBINATION METER ASSEMBLY (SPEED SIGNAL)


    E280659E03
  1. Disconnect the clearance warning ECU assembly connector.

  1. Using an oscilloscope, check the signal waveform of the combination meter assembly.
    Measurement Condition 
    Item
    Content
    Terminal No. (Symbol)
    H131-17 (SPD) - Body ground
    Tool Setting
    5 V/DIV., 20 msec./DIV.
    Condition
    Drive vehicle at 20 km/h (12 mph)

    OK:
    Refer to the illustration.

    HINT:
    As the vehicle speed increases, the wave length shortens.

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Clearance Warning ECU Assembly)
    *b
    Waveform



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - COMBINATION METER ASSEMBLY)
  1. Disconnect the H131 clearance warning ECU assembly connector.

  1. Disconnect the H37 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H131-17 (SPD) - H37-35 (+S)
    Always
    Below 1 Ω
    H131-17 (SPD) or H37-35 (+S) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

GO TO METER / GAUGE SYSTEM (Click here)