Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM

TOYOTA PARKING ASSIST-SENSOR SYSTEM > Taillight Relay Circuit

for Preparation Click here


WIRING DIAGRAM


E300596E02


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK TAILLIGHT
  1. Turn the light control switch to the TAIL position.

  1. Check that the taillight turns on.

    OK:
    Taillight turns on.



NG
GO TO LIGHTING SYSTEM (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BATTERY)


    E270561E08
  1. Disconnect the clearance warning ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    H131-20 (TL) - Body ground
    Ignition switch ON,
    light control switch TAIL
    7 V or higher
    Ignition switch ON,
    light control switch except TAIL
    Below 1.5 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Clearance Warning ECU Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)