Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR SYSTEM

POWER BACK DOOR SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here


HINT:
The following items can be customized.

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Be sure to make a note of the current settings before customizing.
  3. When troubleshooting a function, first make sure that the function is set to the default setting.


CUSTOMIZE
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Customize Setting / Power Back Door System.

  5. Select the setting by referring to the table below.

    Power Back Door System 
    Display (Item)
    Default
    Function
    Setting
    PBD SW Operation
    0.8 s
    Function that turns power back door closer switch on when switch is pushed once or held down for 0.8 sec.
    0.8 s / ON
    PBD Buzzer*
    ON
    This function makes the power back door buzzer sound when power back door is operating
    ON / OFF
    Wirels PBD SW Operation
    0.8 s
    Function that operates power back door when transmitter switch is pressed in specified way
    1 Oper / 2 Oper / 0.8 s / OFF / 1 Motion

    HINT:
    *: The warning buzzer that sounds when the power back door is operating cannot be customized. (Even if this function is set to "OFF", the buzzer will still sound.)