Home › Engine / Hybrid System › 3UR-FE STARTING › IGNITION SWITCH

IGNITION SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY


    A185679
  1. Attach the 2 claws to install the ignition or starter switch assembly.



    A185678
  1. Connect the ignition or starter switch assembly connector.



2. INSTALL LOWER STEERING COLUMN COVER


C160536
  1. Attach the 2 claws to install the steering column lower cover.



3. CUSTOMIZE INFORMATION (for Power Tilt and Power Telescopic Steering Column)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Utility / Customize Setting / Tilt & Telescopic.

  1. Turn the auto away/return function OFF.

  1. Turn the ignition switch to ACC.

  1. Operate the tilt and telescopic switch to fully raise the tilt and extend the steering wheel.

  1. Turn the ignition switch OFF.