POWER BACK DOOR MAIN SWITCH > INSPECTION |
| 1. INSPECT POWER BACK DOOR MAIN SWITCH |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 6 (MSE) - 9 (MSW) | Free | Below 1 Ω |
| 6 (MSE) - 9 (MSW) | Pushed | 10 kΩ or higher |
![]() |
Check the illumination operation.
Connect the positive (+) battery lead to terminal 8 (ILL+) and the negative (-) battery lead to terminal 7 (ILL-), then check that the illumination illuminates.