Home › Engine / Hybrid System › 3UR-FE ENGINE CONTROL › POWER STEERING OIL PRESSURE SWITCH

POWER STEERING OIL PRESSURE SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL POWER STEERING OIL PRESSURE SENSOR
  1. Install a new O-ring to the oil pressure sensor.

  1. Apply a light coat of engine oil to the O-ring of the oil pressure sensor.

    NOTICE:
    1. When reusing the oil pressure sensor, inspect the O-ring.
    2. If the O-ring has scratches or cuts, replace the new O-ring.



    A186999
  1. Using a 24 mm deep socket wrench, install the oil pressure sensor.

    Torque:
    21 N*m{ 214 kgf*cm , 16 ft.*lbf }

  1. Connect the oil pressure sensor connector.



2. ADD POWER STEERING FLUID


3. BLEED POWER STEERING FLUID
  1. Check the fluid level.

  1. Jack up the front of the vehicle and support it with stands.

  1. Turn the steering wheel.

    1. With the engine stopped, turn the wheel slowly from lock to lock several times.

  1. Lower the vehicle.

  1. Start the engine.

  1. Run the engine at idle for a few minutes.

  1. Turn the steering wheel.

    1. With the engine idling, turn the wheel left or right to the full lock position and keep it there for 2 to 3 seconds, then turn the wheel to the opposite full lock position and keep it there for 2 to 3 seconds.(*1)

    2. Repeat (*1) several times.

  1. Stop the engine.



    C124274E02
  1. Check for foaming or emulsification.
    If the system has to be bled twice because of foaming or emulsification, check for fluid leaks in the system.

  1. Check the fluid level.



4. INSPECT FOR POWER STEERING FLUID LEAK


5. INSTALL FRONT FENDER APRON SEAL RH
  1. Install the fender apron seal with the 6 clips.